I’ve been waiting to finish up with some major life stuff before diving into the world of 3D printers. Now that is finally behind me, and I am currently trying to find out which printer I want so that I can place an order.

So far I’ve set my eyes on the new Prusa CORE One. It ticks a lot of the boxes that I think I am after, including:

  • As open as I can get (before going into that Voron-stuff, which I think I’m not ready for). I don’t want to be bogged down with having to run proprietary slicers through Wine and things like that. I am not sure how big of an issue that is with e.g. Bambu or Creality (if at all), but I’ve seen enough rug-pulls and enshittification processes that I don’t really want to risk that. I want to be sure that I can use FOSS tools such as Blender and FreeCAD for design, and similarly open slicers, and the whole workflow will work just fine.
  • As future-proof as I can possibly hope for. I think the upgrade path from the MK4 to CORE One shows that they are serious about sustainability and longevity of their devices, and as far as I can tell, I should have no troubles sourcing replacement parts. I also want to support companies with this philosophy.
  • Has a decent print volume (I know there are bigger, maybe I will be constrained by this at some point?)
  • Enclosed - a major reason I did not want the MK4S was that it was not enclosed (but maybe you can get an enclosure?). It will be placed in my study where I spend most of my computer time (which often times is a lot, so I imagine I will be in the room while it is printing). I imagine, with the additional filter, that it will be better with an enclosure. Also, it will be easier to keep good temperature control during prints, as it can get cold here during winter.
  • Locally produced (I’m EU based).

I understand that other manufacturers provide more “bang for the buck” and that I in that sense will be overpaying feature-wise. I am fine with that given my emphasis on the above criteria.

However, I am a complete newbie to 3D-printing. I am sure there are some limitations I have not thought about, and I was wondering if there are any major things I have not thought about that would actually affect me negatively and should make me reconsider this model?

  • SoulWager@lemmy.mlEnglish
    1·
    6 hours ago

    I think you’ll be happy. Coming from someone that’s had a prusa mini for 3 years.

    I also use FreeCAD, and I don’t think you’ll have a problem with that with any modern slicer, you can export in step to let the slicer do the meshing, or you can use the mesh workbench to get more control over the resolution of the mesh.

    Don’t worry too much about print volume. Can always break stuff up into multiple prints, and that’s often a good idea even if the whole thing would fit inside the print volume.

    I have killed a couple build plates, one from the TPU print sticking too well to PEI, and pulling chunks off, one from crashing the nozzle into it after I switched from a bare metal build plate to a PEI one without changing the Z offset.

    Other than that, I’ve only really replaced one fan that was getting noisy.

    As for filament, I use mostly PLA and ASA, because I don’t need to do anything special to keep those dry enough to print. Probably around 60% PLA, 25% ASA, 15% TPU. PETG is fine, but I need to dry it to keep from getting steam bubbles in my prints, and can’t really be bothered when I can just use ASA or PLA instead.

    As for TPU, it will string like crazy if you don’t dry it, but you can mitigate this with some parts by turning on “avoid crossing perimeters”. Also try to avoid support material with TPU. I now print TPU on the back side(bare metal) of a third party build plate, using a very thin layer of glue stick.